Comparison of PM10 concentrations in high- and medium-volume samplers in a desert environment

The USEPA replaced TSP with PM₁₀ as the National Ambient Air Quality Standard for particulate matter. The commercially available PM₁₀ sampler is a high-volume model using quartz fiber filters. In certain investigations, such as source apportionment studies, chemical analysis of the filter is necessary, however, many analyses cannot be run on quartz filters. An alternate filter such as Teflon is amenable to XRF and ion chemical analyses but is not amenable to analysis for carbon. To overcome these problems DRI constructed a medium-volume PM₁₀ sampler that is capable of collecting particulates on both Teflon and quartz fiber filters simultaneously. This paper describes the design of the DRI medium-volume PM₁₀ sampler, discusses a method for determining equivalence of two samplers, the results of applying the method to test the equivalence of the medium-volume sampler and a commerical high-volume sampler, and examines differences between PM₁₀ and TSP measurements in a southwestern desert.     

A quantitative description of vehicle exhaust particle size distributions in a highway tunnel

During the period May 18-May 22, 1999, a comprehensive study was conducted in the Tuscarora Mountain Tunnel on the Pennsylvania Turnpike to measure real-world motor-vehicle emissions. As part of this study, size distributions of particle emissions were determined using a scanning mobility particle sizer. Each measured size distribution consisted of two modes: a nucleation mode with midpoint diameter less than 20 nm and an accumulation mode with midpoint diameter less than 100 nm. The nucleation and accumulation components in some distributions also exhibited second maxima, which implies that such particle size distributions are superpositions of two particle size distributions. This hypothesis was utilized in fitting the particle size distributions that exhibited second maxima with four lognormal distributions, two for the nucleation mode and two for the accumulation mode. The fitting assumed that the observed particle size distribution was a combination of two bimodal log-normal distributions, one attributed to the heavy-duty diesel (HDD) vehicles and another attributed either to a different class of HDD vehicles or to the light-duty spark ignition vehicles. Based on this method, estimated particle production rates were 1.8 x 10(13) and 2.8 x 10(14) particles/vehicle-km for light-duty spark ignition and HDD vehicles, respectively, which agreed with independently obtained estimates.     

Application of a scenario-based modeling system to evaluate the air quality impacts of future growth

The structure and design of future urban development can have significant adverse effects on air pollutant emissions as well as other environmental factors. When considering the future impact of growth on mobile source emissions, we generally model the increase in vehicle kilometers traveled (VKT) as a function of population growth. However, diverse and poorly planned urban development (i.e., urban sprawl) can force higher rates of motor vehicle use and in return increase levels of pollutant emissions than alternative land-use scenarios. The objective of this study is to develop and implement an air quality assessment tool that takes into account the influence of alternative growth and development scenarios on air quality.The use of scenario-based techniques in land use planning has been around since the late 1940s and been tested in many different applications to aid in decision-making. In this study, we introduce the development of an advanced interactive scenario-based land use and atmospheric chemistry modeling system coupled with a GIS (Geographical Information System) framework. The modeling system is designed to be modular and includes land use/land cover information, transportation, meteorological, emissions, and photochemical modeling components. The methods and modularity of the developed system allow its application to both broad areas and applications.To investigate the impact of possible land use change and urbanization, we evaluated a set of alternative future patterns of land use developed for a study area in Southwest California. Four land use and two population variants (increases of 500k and 1M) were considered. Overall, a Regional Low-Density Future was seen to have the highest pollutant emissions, largest increase in VKT, and the greatest impact on air quality. On the other hand, a Three-Centers Future appeared to be the most beneficial alternative future land-use scenario in terms of air quality. For all cases, the increase in population was the main factor leading to the change on predicted pollutant levels.     

Sources of PM10 and PM2.5 in Cairo’s ambient air

A source attribution study was performed to assess the contributions of specific pollutant source types to the observed particulate matter (PM) levels in the greater Cairo Area using the chemical mass balance (CMB) receptor model. Three intensive ambient monitoring studies were carried out during the period of February 21–March 3, 1999, October 27–November 27, 1999, and June 8–June 26, 2002. PM₁₀, PM_2.5, and polycyclic aromatic hydrocarbons (PAHs) were measured on a 24-h basis at six sampling stations during each of the intensive periods. The six intensive measurement sites represented background levels, mobile source impacts, industrial impacts, and residential exposure. Major contributors to PM₁₀ included geological material, mobile source emissions, and open burning. PM_2.5 tended to be dominated by mobile source emissions, open burning, and secondary species. This paper presents the results of the PM₁₀ and PM_2.5, source contribution estimates.     

The Impact of California Phase 2 Reformulated Gasoline on Real-World Vehicle Emissions

ABSTRACT

In mid-1996, California implemented Phase 2 Reformulated Gasoline (RFG). The new fuel was designed to further decrease emissions of hydrocarbons (HC_s), oxides of nitrogen (NO_x), carbon monoxide (CO), sulfur dioxide (SO₂), and other toxic species. In addition, it was formulated to reduce the ozone-forming potential of the HCs emitted by vehicles. Previous studies have observed that emissions from on-road vehicles can differ significantly from those predicted by mobile source emissions models, and so it is important to quantify the change in emissions in a real-world setting. In October 1995, prior to the introduction of California Phase 2 RFG, the Desert Research Institute (DRI) performed a study of vehicle emissions in Los Angeles' Sepulveda Tunnel. This study provided a baseline against which the results of a second experiment, conducted in July 1996, could be compared to evaluate the impact of California Phase 2 RFG on emissions from real-world vehicles. Compared with the 1995 experiment, CO and NO_x emissions exhibited statistically significant decreases, while the decrease in non-methane hydrocarbon emissions was not statistically significant.

Changes in the speciated HC emissions were evaluated. The benzene emission rate decreased by 27% and the overall emission rate of aromatic compounds decreased by 22% comparing the runs with similar speeds. Emissions of alkenes were virtually unchanged; however, emissions of combustion related unsaturates (e.g., acetylene, ethene) increased, while heavier alkenes decreased. The emission rate of methyl tertiary butyl ether (MTBE) exhibited a larger increase. Overall changes in the ozone-forming potential of the emissions were not significantly different, with the increased contributions to reactivity from paraffins, ole-fins, and MTBE being offset by a large decrease in reactivity due to aromatics.